FLUID FILM AS-R 400 ml Spray can 8pcs set+probe

FLUID FILM AS-R as 400 ml spray can is a universal product for maintenance, preservation, rust dissolving and as a lubricant.

• 400 ml spray can 8pcs set+probe
• Viscosity: low (eg. like sirup)
• Creep ability: + + + +
• Protection: ca. 4 years (in closed cavities)
• Processing: Spray can with additional fine applicator

General usage:

• FLUID FILM AS-R is a physiologically harmless, solvent-free and thixotropic one-layer corrosion protection coating with slip and rust dissolving effect based on lanolin and forms a clear and glossy protective film.
  The 400 ml spray can contains FLUID FILM NAS with propane-butane as propellant.
   
• 400 ml spray can as a universal product for commercial and private use for maintenance, preservation, rust dissolving and as a lubricant.
   
• FLUID FILM AS-R is very suitable for factories, workshops, garages and the do-it-yourselfer for use as a preservative, maintenance product, rust remover and lubricant.
   

• On the car it provides protection for folds, door edges, cavities, engine compartment as well as for all other parts at risk of corrosion. Especially when shut down in winter, even a thin film of FLUID FILM AS-R protects even motorcycles, bicycles or boat parts from rust, also on chains, joints and metal surfaces, such as machines and tools, corrosion is stopped immediately or does not occur at all.

• By combining it as a corrosion inhibitor and lubricant, moving parts such as idler pulleys, chain transmissions or joints can be protected.
   
• FLUID FILM AS-R can be used very effectively for the maintenance of sports, leisure and household equipment or in the restoration sector, where special attention is paid to the original patina.
   
• Unlike conventional products, FLUID FILM AS-R is more environmentally friendly and economical to use due to its solvent-free composition.
   
• The basic substance lanolin is not volatile like oil or kerosene and does not resinify.
  In contrast, the effect of solvents usually wears off after 12-15 seconds, and that of oil or kerosene ends after a few days, at which point these conventional agents completely lose their protective effect.
   
• The insert from the 400 ml spray can allows an even application on large surfaces with the normal spray attachment.
   
• For pinpoint use even in difficult-to-reach places, there is a 15 cm long spray tube on the can. For use in longer cavities, an approx. 60 cm long spray head extension with a 3-jet all-round nozzle can be supplied.

Application:

• Surface may be dry or wet, loose dirt and rust to be removed.
• Surfaces may still be wet but without surface water.

• Spray FLUID FILM evenly on cleaned, dry or wet
  surfaces. If needed, repeat application.
• Hard-to-reach areas to be coated by means of
  the sprayhead with spraytube.
• Coating can be removed easily with fuel and
  other degreasing agents.

• To be stored in a cool and dry place.
• Recommended storage temperature: 15-35°C
• Pressurized gas packaging can be stored for 2 years.

Principal characteristics:

• Behaves extremely resistant to all weather conditions, including snow and slush and the solvent salts used in winter service.
• Extremely effective and reliable at the same time as a rust remover and water-displacing corrosion inhibitor.
• Excellent salt water resistance.
• As corrosion protection of steel parts and other metal parts during transport and processing in the manufacturing plant.
• Fast creeping, yet well adhering, temperature stable, will not be washed off or altered by rain and sea water, nor will it evaporate and gum up, as is the case with most penetrating oils.
• Bitumen protection layers already on the car chassis floors are plasticized by FLUID FILM and thus activated.