FLUID FILM Liquid AR 5 liter

FLUID FILM Liquid AR is a transparent, solvent-free physiologically harmless soft single-layer corrosion protection coating based on lanolin.

• 5 liter
• Viscosity: medium (e.g. like honey)
• Creep ability: + + +
• Protection time: approx. 15 years (in closed cavities)

Features

• Solvent-free and physiologically harmless during processing, greater safety in operation.
• Economical to use and uncomplicated to apply.
• A layer thickness of between 200 - 800 μm can be applied in one operation (by airless spraying).
• Can be sprayed with commercially available airless equipment (compressing over 22:1). Application is possible by brush, rollers or compressed air spraying (with pressure barrel). (see 9.)
• Simplified method of application when spraying by means of lances, which in the majority of cases makes the erection of a scaffold unnecessary.
• 1-component product with excellent adhesion even on damp surfaces and old coatings.
• Excellent penetration of thick rust layers - intensive surface preparation is not necessary (penetrated rust layers can be removed from the substrate).
  rust layers may fall off from the substrate after some time).
• If FLUID FILM Liquid AR has been used as a rust remover, regular repair work or renewal coatings can be carried out immediately with FLUID FILM products only after all loose dirt has been removed.
   

Mode of operation:

• FLUID FILM Liquid AR is a thixotropic product that reduces viscosity by stirring.
  viscosity by stirring and facilitates transfer or filling into other containers.
  into other containers. We recommend the use of mechanical
  stirring equipment.
• The processing temperature for FLUID FILM Liquid AR is between
  -15°C (263 K) and 40°C (313 K). In order to achieve the required
  pressure of 150 bar at the nozzle at low temperatures, we recommend preheating.
  we recommend preheating the material to approx. 25°C.
• During application, the film thickness must be continuously checked to avoid under- or overcoating.
  or overcoating must be checked continuously.
  d.When using the airless spraying method, areas which are difficult to access can be coated by means of lances.
  be coated by means of lances.
• The pneumatic spraying technique can only be used if
  the material is transported to the nozzle under pressure, i.e. when using
  of pressure vessels or combination units.
   

Application data: