BGS 9406 Plastic Plug Assortment, 58 pcs. Features:BGS 9406 Plastic Plug Assortment, 58 pcs.for closing the following bore sizes:10 plugs Ø 10.0 mm10 plugs Ø 13.4 mm10 plugs Ø 13.5 mm8 plugs Ø 19.4 mm10 plugs Ø 19.5 mm10 plugs Ø 22.2 mmin assortment box Technical features:Gross weight: 140 gPackaging suitable for wall hanging: YesEAN: 4026947094069

FLUID FILM Liquid AR 5 liter FLUID FILM Liquid AR is a transparent, solvent-free physiologically harmless soft single-layer corrosion protection coating based on lanolin. 5 liter Viscosity: medium (e.g. like honey) Creep ability: + + + Protection time: approx. 15 years (in closed cavities)   Features Solvent-free and physiologically harmless during processing, greater safety in operation. Economical to use and uncomplicated to apply. A layer thickness of between 200 - 800 μm can be applied in one operation (by airless spraying). Can be sprayed with commercially available airless equipment (compressing over 22:1). Application is possible by brush, rollers or compressed air spraying (with pressure barrel). (see 9.) Simplified method of application when spraying by means of lances, which in the majority of cases makes the erection of a scaffold unnecessary. 1-component product with excellent adhesion even on damp surfaces and old coatings. Excellent penetration of thick rust layers - intensive surface preparation is not necessary (penetrated rust layers can be removed from the substrate). rust layers may fall off from the substrate after some time). If FLUID FILM Liquid AR has been used as a rust remover, regular repair work or renewal coatings can be carried out immediately with FLUID FILM products only after all loose dirt has been removed.     Mode of operation: FLUID FILM Liquid AR is a thixotropic product that reduces viscosity by stirring. viscosity by stirring and facilitates transfer or filling into other containers. into other containers. We recommend the use of mechanical stirring equipment. The processing temperature for FLUID FILM Liquid AR is between -15°C (263 K) and 40°C (313 K). In order to achieve the required pressure of 150 bar at the nozzle at low temperatures, we recommend preheating. we recommend preheating the material to approx. 25°C. During application, the film thickness must be continuously checked to avoid under- or overcoating. or overcoating must be checked continuously. d.When using the airless spraying method, areas which are difficult to access can be coated by means of lances. be coated by means of lances. The pneumatic spraying technique can only be used if the material is transported to the nozzle under pressure, i.e. when using of pressure vessels or combination units.     Application data:   Applied by: Amount of coats Average film thickness in μm Theoretical consumpton in l/m² Theoretical spreading rate in m²/l Nozzle Brush 1 50 0,05 20 - Roller 1 50 0,05 20 - Airspray 1 200 0,2 5 1,5 - 0,4 Airless 1 400-800 0,4 - 0,8 2,5 - 1,25 0,63 - 14