PERMA FILM TRANSPARENT 1 liter standard can

Perma Film from Hodt Fluid Film is an anticorrosive coating for all bare, rusted or with
old coatings and also non-ferrous metals after appropriate pretreatment.

• 1 liter transparent standard can
• Rust protection and paint
• Perfect in combination with Fluid FIlm
• Easy application

Features

• Rust protection and painting in one;
  can be applied directly in the system with FLUID FILM Liquid A/ NAS or AS-R
  (spray) on rust.
• Thanks to its extraordinary penetration properties, FLUID FILM enables
  penetration properties, FLUID FILM allows a thorough wetting and
  encapsulation of rust and/or existing coatings;
• Long-term rust protection;
  good wettability of deep-pored substrates and also joints and
  seams (seam sealing) in the system with FLUID FILM as primer;
  high layer thicknesses are easy to apply by spraying
  hardly any overspray;
  low material loss

Application:

• Bare ferrous metals:
  Sand very smooth surfaces. Remove grinding dust. Clean surface carefully with solvent.
• Rusted ferrous metals:
  Remove loose particles with wire brush or clean by high pressure washing. Allow to dry after washing.
• Zinc or galvanized surfaces:
  As weathering progresses, zinc or galvanized surfaces become dull and rough, and zinc salts form on the surface (white coating). This coating must be removed before coating, otherwise no adhesion is possible. For this purpose, an "ammoniacal wetting agent wash" is used. This consists of water and ammonia solution (10:1) with a few drops of washing-up liquid. With this solution and abrasive fleece, the surface is carefully worked until a grayish foam is formed. Leave to act for 10 minutes, then rinse thoroughly with water and allow to dry.

• A dry film thickness of at least 150 μm is a prerequisite for safe
  layer thickness of at least 150 μm. (Wet film thickness 250 μm).
• This film thickness is achieved after 2 - 3 applications when applying by brush or roller, and after
  2 - 3 applications, by spraying after 1 application.
• PERMA FILM is very thixotropic and can therefore be applied without sagging in the
  up to a wet film thickness of 250 μm in one application without
  applied in one working step.
• For higher film thicknesses, several coats are necessary,
• For higher film thicknesses, several coats are necessary.
  air must be ensured.

Substrates:

• Bare, rusted or with old coatings provided ferrous metals.
  Non-ferrous metals after previous treatment
  Wooden subfloor areas
• The use of the primer FLUID FILM Liquid A/NAS or
  AS-R fulfills the following tasks:
  Penetration to the underside through dense rust or existing
  Wax or bitumen based coatings;
  Blocking loose edges, cracks and folds;
  The application of FLUID FILM also eliminates
  possible stresses due to excessive shrinkage and hardening of the PERMA FILM
  and hardening of the PERMA FILM coating and prevents the layers from
  that the layers peel off from the rusty substrate;
  Any residual moisture is displaced by the penetration of FLUID
  FILM is displaced.
  A low layer thickness reduces the risk that an excessive
  of the primer will not penetrate into the subsequent PERMA FILM coat, thus
  and thus prolongs or even prevents curing.